How To Change Your Dynamic IP Address.

1. Click on "Start" in the bottom left hand corner of screen

2. Click on "Run"

3. Type in "command" and hit ok

4. Type "ipconfig /release" just like that, and hit "enter"

5. Type "exit" and leave the prompt

6. Right-click on "Network Places" or "My Network Places" on your desktop.

7. Click on "properties"

You should now be on a screen with something titled "Local Area Connection", or 

something close to that, and, if you have a network hooked up, all of your other 

networks.

8. Right click on "Local Area Connection" and click "properties"

9. Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab.

10. Click on "Use the following IP address" under the "General" tab.

11. Create an IP address (It doesn't matter what it is. I just type 1 and 2 until i fill the 

area up).

12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default 

numbers.

13. Hit the "Ok" button here

14. Hit the "Ok" button again

You should now be back to the "Local Area Connection" screen.

15. Right-click back on "Local Area Connection" and go to properties again.

16. Go back to the "TCP/IP" settings

17. This time, select "Obtain an IP address automatically"
tongue.gif 

18. Hit "Ok"

19. Hit "Ok" again

20. You now have a new IP address

With a little practice, you can easily get this process down to 15 seconds.

Note-: This only changes your dynamic IP address, not your ISP/IP address. 

If you plan on hacking a website with this trick be extremely careful, 

because if they try a little, they can trace it back.

Only For Educational Purposes